Error Correction; Maintenance And Cleaning; Note To The Tool Set; Accessories - IKA WERKE T 10 basic Mode D'emploi

The entire unit may also be arranged somewhat off centre in order
to avoid any undesired air admission caused by the strong rotatio-
nal turbulence.
Set the adjusting wheel (2) to the minimum speed before swit-
ching on the appliance. You can read off the set speed by compa-
ring the numbers on the adjusting wheel (2) and the speed table
(see chapter: Speed Table).
By using the adjustment wheel (2) the speed may be infinitely
varied to meet the requirements of the medium to be processed.
The no-load speed of the T 10 basic driving unit may be set
between 8.000 and 30.000 1/min.
The driving unit is switched on by means of the rocker switch (1).

Error correction

The equipment is appropriate for short-time duty (10 min ON / 5
min OFF), i.e. indicated fall times must be considered. During
neglect the equipment can switch off depending upon load by
temperature rise during the enterprise, since the drive is equipped
with an overload safety device, which switches the equipment off
with overload or temperature rise. If the equipment switched off
at the On-/ Off- switch. After an appropriate cooling time the
equipment can be restartet.
Note: The equipment does not restart it after responding the over-
load safety device automatically, must for cooling at the rocker
switch (1) be switched off.

Maintenance and cleaning

Drive unit:
The drive unit is maintenance-free but not immune from wear. The car-
bon brushes of the motor wear down over the time. To clean the drive
use only water with a detergent that contains tensides, or use isopro-
pylalcohol for stubborn soiling.
T10B 022005
Dispersion tools:
Consider please the manuals associated to the dispersion tools.

Note to the tool set

The provided assembly tools (flat key and shaft key, fig. 4) can be
used to disassemble and assemble the dispersing elements for
cleaning and maintenance. Take the information about the exactly
use of the operating instructions of the dispersion tools.

Accessories

• R 1825 Plate stand
• R 104 Stand
• R 182 Cross sleeve
• H 44 Cross sleeve
15