Troubleshooting - Scheppach MP43-40Li Traduction Des Instructions D'origine

12. Troubleshooting

Problem Possible cause
The device does not • The battery is flat.
start.
• The safety lock button (2) is faulty.
• The motor is faulty.
• The safety plug (12) is missing.
The motor stops during • The battery is flat.
operation. • The battery is not inserted correctly.
• The battery is faulty.
Decreased • The battery is exhausted.
performance • The battery is not fully charged.
• The grass is too long.
Excessive vibration • The blades are installed incorrectly.
• Foreign object impeding the blades
• The blades are damaged.
Inadequate grass • The grass box is full.
intake • The ejection opening is obstructed.
• The cutting height is set too low.
Lawn is cut irregularly. • The blades are blunt.
• The grass is too long.
30 GB
 www.scheppach.com  service@scheppach.com  +(49)-08223-4002-99  +(49)-08223-4002-58
Solution
• Check the battery. If required, arrange repair
by an authorised electrician.
• Repair by an authorised service centre
• Repair by an authorised service centre
• Insert the safety plug (12).
• Charge the battery.
• Re-insert the battery.
• Clean the terminals, replace with an original
battery.
• Replace the battery.
• Charge the battery.
• Cut it in phases.
• Check the blades' positioning.
• Clean the blades.
• Replace the blades.
• Empty the grass box.
• Remove the grass.
• Change the cutting height.
• Have the blades sharpened/replaced.
• Cut it in phases.