Information; Movement; Transport; Checks On Reception - AERMEC VED 030 I Manuel D'utilisation Et D'entretien, Instructions D'installation

4.

INFORMATION

During the phases of installation, main-
tenance and cleaning provide suitable
Personal Protective Equipment (PPE).
The unit must not be used as a store
or for spare parts. Any use not detailed
in this manual can cause danger and is
forbidden. The unit must be installed by
a qualified technician in accordance with
the local legislation and standards and
whilst respecting the minimum clearance
dimensions for maintenance.
Before the installation ensure that the
unit has not suffered any damage during

transport:

• use of a damaged unit may be
dangerous
• the support structure must be
able of supporting the weight of the unit.
Note:
For any future reference or communica-
tion with AERMEC S.p.A. it is necessary
to state the unit serieal number.
4.1.

MOVEMENT

WARNING!
During the movement phase provide
suitable Personal Protective Equipment
(PPE).
Before installation and use it is recom-
mended to completely remove the pack-
aging of the unit and all the components
supplied loose.
4.2. TRANSPORT
To safely transport the unit refer to the
weight data shown on the nameplate.
In all events transport must be carried out
with the following precautions:
• the unit and any accessories
must not be subjected to any violent
shocks to avoid compromising the integ-
rity of the unit and its internal compo-
nents.
• the unit and any accessories
must be securely mounted on the method
of transport using ropes or any other
means that prevents movement.
• the unit and any accessories
must be protected from shocks during
transportation.
• the unit and any accessories
must always be protected from the
weather during transportation or storage.
4.3.

CHECKS ON RECEPTION

On receipt of the unit carry out an initial
visual check to ensure:
• the transportation documents
correspond with the order documents.
• the integrity of the packaging
• that all components are pre-
sent.
If any damage or missing components are
found then this must be indicated on the
transportation documents.
4.4.

INSTALLATION

It is recommended to carefully follow
the instructions provide in the follow-
ing paragraphs for the installation. The
paragraphs are arranged chronologically
in order to facilitate each stage of instal-
lation. The unit is designed for installation
internally and not externally.
Before carrying out the installation check
the clearance spaces required:
• for the operator to complete
the installation
• for the intake and discharge
ducting
• to the condensate drainage
• to the cleaning of the filter
• to the cleaning of the coil.
To ceiling or wall mount the unit it is
necessary to use the four mounting hoes
provided in the unit frame.
4.5.

CONTROL DEVICE

(not included)
Use a control device with thermostat and
speed control of the fan with a 0-10V out-
put and with characteristics compatible
with the fan coil unit.
Aermec provides control panels that per-
mit the control of a single unit or of a unit
inserted into a system with multiple units.
For the selection refer to the unit manu-
als and the control panel accessories and
the VMF System.
4880950_03 - 1811
23