X-Tra Power XPA12/24 -2 Traduction Des Instructions De Service D'origine page 12

Malfunction
Reverse connection LED [11] is not lit.
Reverse connection LED [11] is lit red.
LEDs [2] and [10] light red.
Device switches off after start-up attempt.
Cleaning and maintenance
Cleaning and maintenance
Important!
Important!
The device may only be cleaned with
the mains plug disconnected.
The device may only be cleaned
with the mains plug disconnec-
ted.
Environmental protection
Environmental protection
Do not dispose of the device with
domestic waste. Have the device
Do not dispose of the device with
disposed of by an authorised waste
domestic waste. Have the device
management company or your
disposed of by an authorised waste
management company or your municipal waste management
municipal waste management or- organisation. Adhere to the applica-
ganisation. Adhere to the applicab- ble regulations. In case of doubt
contact your waste management organisation. le regulations. In case of doubt
Recycle all packaging material in an environmen-
contact your waste management organisa-
tally friendly manner.
tion. Recycle all packaging material in an
environmentally friendly manner.
Batteries:
Do not dispose of batteries with domestic waste,
Batteries:
do not expose to fire or water. Collect and recy-
Do not dispose of batteries with domestic
cle batteries or dispose of with due care for the
waste, do not expose to fire or water. Collect
environment.
and recycle batteries or dispose of with due
care for the environment.
12
12
Notes on troubleshooting
Cause
– Booster cable clamps are not connected.
– Vehicle battery voltage is less than 4 V or vehicle bat-
tery is missing altogether.
– Booster cable clamps are connected incorrectly.
– Charge of booster kit too low; charging not possible.
– Vehicle causes a short circuit; remove defective
vehicle battery
For this Würth appliance the following guarantees
For this X-TRAPOWER appliance the following apply:
guarantees apply: – Battery booster kit and charger: 24 months
–Battery booster kit and charger: 24 months – Battery in battery booster kit: 12 months
–Battery in battery booster kit: 12 months – Cable clamps and fuses are excluded as they are
–Cable clamps and fuses are excluded as they
The warranty period starts with the date of purchase
(verified by invoice or delivery document).
The warranty period starts with the date of
Faults covered by warranty shall be eliminated by
purchase (verified by invoice or delivery do-
replacement or repair. Damage caused by improper
cument). Faults covered by warranty shall be
operation is not covered by warranty.
eliminated by replacement or repair. Damage
caused by improper operation is not covered by Claims under warranty shall only be considered if
warranty. the device is returned fully assembled to a Würth
agency, your Würth sales representative or a
Claims under warranty shall only be considered
if the device is returned fully assembled to a customer service workshop for electrical equipment
X-TRAPOWER a customer service workshop for
authorised by Würth. Technical changes reserved.
electrical equipment authorised by X-TRAPO- We accept no liability for printing errors.
WER. Technical changes reserved. We accept no
liability for printing errors.
In the unlikely event of a failure or defect, have the
device repaired by a Würth masterService work-
shop. In all your queries and spare part orders,
In the unlikely event of a failure or defect, have
always quote the product number (see type plate) of
the device repaired by a X-TRAPOWER work-shop.
your device.
In all your queries and spare part orders, always
quote the product number (see type plate) of
your device.
Warranty
Warranty
wear parts.
are wear parts.
Accessories and spare parts
Accessories and spare parts