Sharp LL-H1813 Mode D'emploi page 26

The DVI-I input connector pin
(DVI-I connector with 29 pins)
Power management
The monitor is based on the VESA DPMS and the DVI DMPM standards.
To activate the monitor's Power Management function, both the video card and the computer must
conform to the VESA DPMS standard and the DVI DMPM standard.
DPMS: Display Power Management Signalling
DPMS mode Screen
ON Display on
STANDBY
SUSPEND Display off
OFF
DDC (Plug & Play)
This monitor supports the VESA DDC (Display Data Channel) standard.
DDC is a signal standard for carrying out Plug & Play functions on the monitor or PC. It transfers informa-
tion such as degree of resolution between the monitor and PC. You can use this function if your PC is
DDC compliant and if it is set so that it can detect the Plug & Play monitor.
There are many varieties of DDC due to the differences between systems. This monitor works with
DDC2B.
Specifications
No. Function
10 TMDS data 1+
11 TMDS data 1/3 shield
12 N.C.
13 N.C.
14 +5V
15 GND
Power H-sync V-sync
consumption
51W* Yes
No
5W Yes
No
*Not using USB hub
1 TMDS data 2-
2 TMDS data 2+
3 TMDS data 2/4 shield
4 N.C.
5 N.C.
6 DDC clock
7 DDC data
Analog vertically synchronised
8
signal
9 TMDS data 1-
DMPM: Digital Monitor Power Management
DMPM mode
ON
Yes
OFF
Yes
No
No
26
No. Function
16 Hot plug detection
17 TMDS data 0-
18 TMDS data 0+
19 TMDS data 0/5 shield
20 N.C.
21 N.C.
22 TMDS clock shield
23 TMDS clock +
24 TMDS clock -
C1 Analog red image signal
C2 Analog green image signal
C3 Analog blue image signal
Analog horizontally synchro-
C4
nised signal
C5 Analog GND
Screen Power
consumption
Display on 51W*
Display off 5W
*Not using USB hub