Cover And Cushion Insert Removal; Cover And Cushion Insert Replacement; Cleaning And Disinfecting Product - ROHO Hybrid ELITE Mode D'emploi

COVER AND CUSHION INSERT REMOVAL:

To Remove The Cover:
1. Unzip the zipper.
2. Carefully push the inflation valve(s) back through the valve opening(s) in the cover.
3. Gently remove contoured foam base and cushion insert from cover.
To Remove the Cushion Insert:
1. Gently remove the inflation tube(s) from the groove(s) in the contoured foam base.
2. Extract the inflation tube(s) from the corresponding hole in the foam base corner by gently pushing
and pulling until the entire tube, including the valve, is out.
3. Peel the cushion insert away from the foam base and separate the Velcro strips.

COVER AND CUSHION INSERT REPLACEMENT:

To Replace the Cushion Insert:
1. Place the cushion insert, cell side up, in the cutout section of the contoured foam base with the BACK
of the cushion insert facing the BACK of the foam base. Refer to directional labels.
2. Line up the Velcro strips on the bottom of the cushion insert and top of the foam base then press
firmly to secure.
3. Insert the inflation valve(s) into the corresponding hole on the back corner of the foam base and
carefully push the inflation tube(s) through until the valve(s) protrude on the side.
4. Gently pull the inflation tube(s) toward the front of the cushion until the tube(s) extend the length of
the foam base.
5. Press the inflation tube(s) into the groove(s) in the foam base. Inflation valve(s) must be accessible
in the front of the cushion.
To Replace The Cover:
1. Place cover with non-skid surface side facing DOWN and zipper unzipped. Refer to directional patch
for confirmation of orientation.
2. With the cushion insert placed into the contoured foam base, insert the cushion into the cover FRONT
first, cells up.
3. Reach inside the cover valve openings and carefully pull the inflation valve(s) through the opening(s).
4. Zip the cover. If hook Velcro strips were removed prior to washing, replace the strips.
5. Follow adjustment instructions.

CLEANING AND DISINFECTING PRODUCT:

Cleaning and disinfecting are two separate processes. To be effective, cleaning must precede
disinfecting. Product components must be cleaned and disinfected separately. Product must be cleaned,
disinfected and checked for proper functioning between multiple patient use.
To Clean the Cover: Remove the cover from the cushion. If detachable hook Velcro strips are in
place on bottom of cover, remove prior to washing to help prevent damage to cover or
other fabrics in wash. Machine wash cover in warm water (105°F / 40°C) with mild
detergent, gentle cycle, or wipe clean with neutral detergent and warm water. Tumble
dry low.
To Disinfect the Cover: Hand wash in warm water using 1/2 cup household liquid bleach
per quart of water (125 ml bleach to 1 liter of water), then rinse thoroughly. The cover can
also be machine washed in hot water (140°F / 60°C) to disinfect. Tumble dry low.
NOTE: Follow safety guidelines on bleach container.
8