AEG IAE64843FB Notice D'utilisation page 17

9.1 What to do if...
Problem
You cannot activate or oper-
ate the hob.
An acoustic signal sounds
and the hob deactivates.
An acoustic signal sounds
when the hob is deactivated.
The hob deactivates.
Residual heat indicator does
not come on.
You cannot activate the
highest heat setting.
The sensor fields become
hot.
There is no sound when you
touch the panel sensor
fields.
Possible cause
The hob is not connected to
an electrical supply or it is
connected incorrectly.
The fuse is blown.
You do not set the heat set-
ting for 60 seconds.
You touched 2 or more sen-
sor fields at the same time.
Pause operates.
There is water or fat stains
on the control panel.
You put something on one
or more sensor fields.
You put something on the
sensor field .
The zone is not hot because
it operated only for a short
time or the sensor is dam-
aged.
Another zone is already set
to the highest heat setting.
The Power limitation level is
too low.
The cookware is too large or
you put it too near to the
controls.
The sounds are deactivated.
ENGLISH
Remedy
Check if the hob is correctly
connected to the electrical
supply. Refer to the connec-
tion diagram.
Make sure that the fuse is
the cause of the malfunction.
If the fuse is blown again
and again, contact a quali-
fied electrician.
Activate the hob again and
set the heat setting in less
than 60 seconds.
Touch only one sensor field.
Refer to "Daily use".
Clean the control panel.
Remove the object from the
sensor fields.
Remove the object from the
sensor field.
If the zone operated suffi-
ciently long to be hot, speak
to an Authorised Service
Centre.
First reduce the power of the
other zone.
Change the maximum pow-
er in the Menu. Refer to
"Daily use".
Put large cookware on the
rear zones if possible.
Activate the sounds. Refer to
"Daily use".
17