Manual Screen Adjustment - Sharp LL-T1610W Manuel D'utilisation

Adjusting the screen display (when using an analog signal)

Manual screen adjustment

Adjustments can be made using On Screen Display
(OSD) Menu provided.
1. Display an image that makes the entire screen very
bright. If using Windows, you can open and use the
Adjustment Pattern on the accompanying Utility Disk.
(p. 19)
2. Press the MENU button.
The ADJUSTMENT Menu will be displayed.
At this point relevant menu options can be adjusted.
Each time the MENU button is pressed the next menu
is selected. (ADJUSTMENT → GAIN CONTROL →
WHITE BALANCE → MODE SELECT → OSD Menu
disappears)
Notes:
• The OSD Menu automatically disappears
approximately 30 seconds after the last command.
• This explanation is based on using the Adjustment
Pattern (for Windows) to make adjustments.
ADJUSTMENT Menu
MANUAL: Individual menu options are manually
adjusted.
AUTO: Every menu option is automatically adjusted.
Notes:
• Press the button to select [AUTO].
• To choose a menu option:
• To go to the next menu:
CLOCK
The figure below demonstrates how to adjust so that
vertical flicker noise is not emitted. (
PHASE
The figure below demonstrates how to adjust so that
horizontal flicker noise is not emitted. (
Note:
•
H-POS (horizontal positioning) and V-POS (vertical
positioning)
To center the screen image within the boundaries of the
screen, adjust the left-right (H-POS) values and the up-
down (V-POS) values. (
Notes:
•
SELECT button
MENU button
20
Vertical flicker noise
Adjustments to PHASE should be made only after
CLOCK has been correctly set.
Horizontal flicker noise
buttons)
Adjustment
Pattern
About the ADJUSTMENT Menu
The ADJUSTMENT Menu can be reset to its ex-
factory values in one command.
1. Turn the monitor power on.
2. Press the MENU button and the
same time.
When [RESET] appears on the screen the reset
is complete.
buttons)
buttons)
Screen frame
button at the