Hints And Tips - Zanussi ZDF12001WA Notice D'utilisation

Table des Matières

Publicité

Les langues disponibles
  • FR

Les langues disponibles

3. Start the shortest programme with a rinsing
phase, without detergent and without
dishes.
4. Adjust the water softener to the water hard-
ness in your area.
5. Adjust the released quantity of rinse aid.
Setting and starting a programme
Setting mode
The appliance must be in setting mode to
start a programme.
Turn the programme knob until the programme
marker is aligned with a programme on the con-
trol panel. If
comes on and
the appliance is in setting mode.
If the control panel does not show this condi-
tion, press and hold, at the same time
until the appliance is in setting mode
Starting a programme
1. Open the water tap.
2. Close the appliance door.
3. Turn the knob until the programme marker is
aligned with the symbol of the programme
you want to set.
comes on.
starts to flash.
4. Press
to start the programme.
and
are on.
Opening the door while the appliance
operates
If you open the door, the appliance stops. When
you close the door, the appliance continues
from the point of interruption.

Hints and tips

The water softener
Hard water contains a high quantity of minerals
that can cause damage to the appliance and
bad washing results. The water softener neutral-
ises these minerals.
The dishwasher salt keeps the water softener
clean and in good conditions. It is important to
set the right level of the water softener. This
www.zanussi.com
Cancelling the programme
1. Press and hold
programme.
At the end of the programme
When the programme is completed
on. If you do not deactivate the appliance within
5 minutes all indicators goes off. This helps to
decrease energy consumption.
1. To deactivate the appliance, turn the knob
starts to flash
2. Close the water tap.
and
Important
• Let the dishes become cold before you re-
• First remove the items from the lower basket,
• There can be water on the sides and on the
makes sure that the water softener uses the
correct quantity of dishwasher salt and water.
Using salt, rinse aid and detergent
• Only use salt, rinse aid and detergent for
flash.
Make sure that there is detergent in the de-
tergent dispenser before you start a new
until the programme marker is aligned with
.
move them from the appliance. Hot dishes
can be easily damaged.
then from the upper basket.
door of the appliance. Stainless steel be-
comes cool more quickly than the dishes.
dishwasher. Other products can cause dam-
age to the appliance.
and
until
starts to
comes
31

Publicité

Table des Matières
loading

Table des Matières