Zanussi ZDF12001WA Notice D'utilisation page 29

German
degrees
(°dH)
37 - 42
29 - 36
23 - 28
19 - 22
15 - 18
11 - 14
4 - 10
< 4
1) Factory position.
2) Do not use salt at this level.
How to adjust the level of the water
softener
1. Make sure that the programme marker on
the knob is aligned with
2. Press and hold
the knob counterclockwise until the pro-
gramme marker is aligned with
3. Release
when
4. Press
.
•
starts to flash.
•
and continue to flash.
• The intermittent flashing of
the current set level,, e.g. 5 flashes +
pause + 5 flashes = level 5.
5. Press
again and again to change the set-
ting. Each time you press
ber increases.
6. To confirm the setting and deactivate the
appliance, turn the knob until the pro-
gramme marker is aligned with
Filling the salt container
Caution! Water and salt can come out
from the salt container when you fill it. Risk
of corrosion. To prevent it, after you fill the salt
container, start a programme.
www.zanussi.com
Water hardness
French mmol/l
degrees
(°fH)
65 - 75 6.5 - 7.5
51 - 64 5.1 - 6.4
40 - 50 4.0 - 5.0
33 - 39 3.3 - 3.9
26 - 32 2.6 - 3.2
19 - 25 1.9 - 2.5
7 - 18 0.7 - 1.8
< 7 < 0.7
.
. At the same time turn
.
and start to flash.
refers to
the level num-
.
Clarke
degrees
46 - 52
36 - 45
28 - 35
23 - 27
18 - 22
13 - 17
5 - 12
< 5
1
3
Put 1 litre of water in the salt container (only for
the first time).
Water softener
adjustment
Level
8
7
6
1)
5
4
3
2
2)
1
2
4
29