Table des Matières
Publicité
Troubleshooting Guide
Hilfestellung zur Problemlösung
ENGINE DOES NOT START
ENGINE STARTS THEN STALLS
ENGINE IS RUNNING, BUT VEHICLE DOES NOT MOVE
ERRATIC CONTROL
60
Possible Cause
Out of fuel
Choke lever is in the wrong position
Engine fl ooded
Air fi lter is clogged
Vent hole in gas cap is plugged
Pull start is not working
Fuel mixture is old or bad
Spark plug is not working
Throttle servo failed/Setup is wrong
Carburetor is incorrectly adjusted
Engine stop switch is malfunctioning
Piston and cylinder is worn
Out of fuel
Air fi lter is clogged
Vent hole in gas cap is plugged
Engine may be overheated
Engine idle is too low
Carburetor is incorrectly adjusted
Clutch is slipping or locked-up
Fuel mixture is old or bad
Throttle servo is improperly set up
Drivetrain is not functioning properly
Brakes are stuck
Drivetrain is damaged
Receiver battery capacity is low
Radio is not responding despite charged
battery
Transmitter and/or receiver batteries are weak Install new batteries in the transmitter. Recharge the receiver battery.
Connectors are inserted improperly
Brake is not working
Guide de dépannage
Guida alla soluzione dei problemi
Solution
Refi ll the tank and follow starting instructions.
Make sure the choke lever is in the correct position.
Refer to starting instructions
Remove the spark plug. Pull start 3–5 times. Replace and test.
Check and replace if necessary.
Clean the vent hole if plugged or dirty.
Check the pull starter and clean or replace if necessary.
Mix fresh fuel per instructions.
Check the spark plug and ignition coil and replace if necessary.
Check servo operation. Set it to neutral and reset the linkage according
to your radio and model manufacturer's specifi cations.
Return the carburetor to the factory settings and retune if necessary.
Check and replace the stop switch if necessary.
Check the piston and cylinder for wear or damage and replace if
necessary.
Refi ll the tank and follow starting instructions.
Check and replace if necessary.
Clean the vent hole if plugged or dirty.
Let the engine cool. Reset the carburetor to factory settings and restart.
Follow the instructions to increase idle speed.
Return the carburetor to the factory settings and retune if necessary.
Check the clutch for worn/broken lining or spring.
Mix fresh fuel per instructions.
Set the servo to neutral and reset the linkage according to radio and model
manufacturer's specifi cations.
Check the drivetrain for smooth operation/damage.
Look for damage or foreign matter locking the brakes.
Check for damaged driveshaft or diff. Replace as needed.
Charge the receiver battery.
Make sure binding is properly set up.
Check the connectors and reinstall if necessary.
Check the servo, brakes, and linkage for damage. Repair/replace/reset
the servo linkage to factory settings.
DESERT BUGGY XL • INSTRUCTION MANUAL
Publicité
Table des Matières
