Troubleshooting Guide - Horizon Hobby ProBoat SHOCKWAVE PRB0600 Manuel De L'utilisateur

EN

Troubleshooting guide

problem
Boat will not respond
to throttle but responds
to other controls
Extra noise or extra
vibration
Reduced runtime or
boat underpowered
Boat will not Bind
(during binding) to
transmitter
Boat will not link (after
binding) to transmitter
Boat tends to dive in
the water or takes on
water
Boat tends to turn one
direction
10
possible Cause
Throttle servo travel is lower than 100% Make sure throttle servo travel is 100% or greater
Throttle channel is reversed
Damaged propeller, shaft or motor
Propeller is out of balance
Boat battery charge is low
Boat battery is damaged
Blocking or friction on shaft or propeller
Boat conditions may be too cold
Battery capacity may be too low
for conditions
Drive dog is too close
Too little lubrication on flex shaft
Vegetation or other obstacles block
the rudder or propeller
Transmitter is too near boat during bind-
ing process
Boat or transmitter is too close to large
metal object
Boat battery/Transmitter battery charge
is too low
ESC switch is off
Transmitter is too near boat during link-
ing process
Boat or transmitter is too close to large
metal object
Boat battery/transmitter battery charge
is too low
ESC switch is off
The boat hull is not completely closed
Center of gravity is too far forward
Trim tabs are angled incorrectly on
the back of the boat
Rudder or rudder trim is not centered
Vertical fins of trim tabs are angled
incorrectly
Solution
Reverse throttle channel on transmitter
Replace damaged parts
Balance or replace propeller
Completely recharge battery
Replace boat battery and follow
battery instructions
Disassemble, lubricate and correctly align parts
Make sure battery is warm before use
Replace battery or use a larger capacity battery
Loosen coupling at flex shaft and move out flex
shaft a small amount
Fully lubricate flex shaft
Remove boat from the water and obstacles
Move powered transmitter a few feet from boat,
disconnect and reconnect battery to boat
Move boat or transmitter away from large metal
object
Replace/recharge batteries
Power on ESC switch
Move powered transmitter a few feet from boat,
disconnect and reconnect battery to boat
Move boat or transmitter away from large metal
object
Replace/recharge batteries
Power on ESC switch
Dry out the boat and ensure the hatch is fully
closed on the hull before returning the boat
to the water
Move batteries back in the hull
Angle each trim tab up a small amount to lift the
bow or down a small amount to lower the bow
Repair rudder or adjust rudder and rudder trim
for straight running when control is at neutral
Angle the fins a small amount right or left so
that the boat goes straight when the rudder
is at neutral
Shockwave 26