Leds And Error Signaling On Device - Knick SensoTrans P 32300 P0 Série Mode D'emploi

LEDs and Error Signaling on Device

Note: Green and red LEDs fl ash momentarily at device startup.
Green: Supply voltage provided
Yellow:For RTD measurement, the identifi ed connection type is
signaled once at the start
(2/3/4-time blinking corresponds to 2/3/4-wire measurement)
Blinking:
Constant light: IrDA connected
Red: Error status; LED blinking indicates error number
No. Error
Value below range limit
Value above range limit
Sensor short circuit**
Sensor open**
Pot/Strain gauge: resistance error**
SIL only:
Output load error
Identifi cation of connection**
Switch misadjusted**
Adjustment error**
Device error (P 32300 P0/...) *
Device error SIL*
* Self-locking error
** Self-locking error for P 32300 P0/1x
IrDA active
Output [mA]
3.6
3.6
< 3.6
< 3.6 < 3.6
Output [V]
5.25 10.5
5.25
10.5
5.25 10.5
5.25 10.5
5.25 10.5
5.25 10.5
5.25 10.5
< 0.1 < 0.1
45