Intended Use; Block Diagram - Knick SensoTrans P 32300 P0 Série Mode D'emploi

Intended Use

The SensoTrans® R P 32300 resistance transmitters provide connection
possibilities for all standard resistors and potentiometers for angle,
path, or position detection up to 50 kΩ.
When a resistive sensor is connected, 2-, 3-, or 4-wire confi guration is
automatically recognized at device startup.
The output signal is adjustable to 0 / 4 ... 20 mA, or 0 ... 5 / 10 V.
The calibrated range selection is performed using DIP and rotary
encoder switches. Alternatively, the devices can be confi gured via an
IrDA interface located in the upper part of the unit. The device comes
with 24 V DC power supply and galvanic 3-port isolation.
Prior to commissioning and after each change of the confi guration,
you must check the intended function of the transmitter (see Safety
Manual, section 5.1 "Functional Checks").

Block Diagram

Input
R, Ratio
Note:
When the confi guration is changed from 2-wire to 3-wire (or
4-wire) or from 3-wire to 4-wire, this is only recognized after
the device's next restart.
34
Power supply
24 V DC
110 ... 230 V AC
Output
0(4) ... 20 mA
0 ... (5)10 V