Notes On Programming - IFM Electronic ecomat200 FD-2 Notice D'utilisation

Notes on programming

RUN mode
During programming the unit internally remains in the RUN mode! (RUN indicator
visible).
This means that until a new value is acknowledged with the push button
unit carries out its monitoring function on the basis of the previously set parame-
ters and switches the relay and transistor outputs accordingly.
Note:
The monitoring function of the monitor is deactivated by continuously pressing the
button in the RUN mode. The deactivation is effective as long as the push but-
ton is pressed.
Time Out Function
If during programming no push button is pressed for approx. 15 s, this is seen as a
cancellation.
Parameter changes which are not acknowledged with the
rejected. The previously set parameter value is restored and remains effective for
the monitoring functions.
Numerical entries
Press the or push button and hold it.
The smallest decade becomes active and is counted up or down depending on the
selected push button (e.g. 1, 2, 3, .... 0). Then comes the next decade, etc.
As soon as the push button is released, the active decade flashes. It is set by pressing
the or push button several times. The preceding decade then flashes and can be
set.
Factory reset
The factory default values can be restored by pressing the
simultaneously during power on. All entered parameter values are lost.
KEY function
The unit can be locked to prevent incorrect entries.
• Locking:
Press the push buttons
flashes. Release the push buttons when the KEY indicator is continuously indicat-
ed.
• Unlocking:
Press the push buttons
flashes. Release the push buttons when the KEY indicator is no longer indicated.
/ simultaneously and hold them. The KEY indicator
/ simultaneously and hold them. The KEY indicator
FD-2
MONITOR
the
push button are
and push buttons
page 31