Navigation And Parameter Table - IFM Electronic ecomat200 FD-2 Notice D'utilisation

FD-2
MONITOR

7. Navigation and parameter table

The push buttons
of values and acknowledgement within the parameters arranged in columns.
The parameters above
normally set only once during commissioning depending on the machines or sys-
tems to be monitored.
The parameters below these entries are application parameters. They can be set or
changed more often.
RUN
Mode
selective
indication
Istwert
actual value
Eingang 1
input 1
[RPM/Hz]
[RPM/Hz]
Dreh-
direction of
richtung
rotation
0DIR
no pulse
sequence or
direction of rota-
tion detected
1DIR
IN1 before IN2
2DIR
IN2 before IN1
page 26
/ and the push button
and
VER
DIM
EVM
NC1
FP1
SC1
ST1
SO1
CT1
DT1
FT1
are used for the navigation, entry
are general system parameters. They are
parameter range
and PRG mode
SO2
CT2
DT2
FT2
system
parameter
back to the
RUN mode
application
parameters