Pre-Installation Instructions - Dometic Midi Heki Style 400 x 700 Instructions De Montage Et De Service

Pre-installation instructions

6 Pre-installation instructions
➤ Before installation, check the roof thickness of your vehicle. Consult the
vehicle manufacturer if you have any questions.
➤ When choosing the installation location, observe the following:
– Adjoining components (roof rack or attachment and reinforcing parts),
cables and cabinets in the vehicle interior must not get damaged when
sawing the hole.
– Sufficient space needs to be available for installing the inner and outer
frames.
– Only fit the roof light on flat and parallel interior and exterior roof areas
with a maximum inclination of 15° to the horizontal.
– You may use an existing roof hole provided the roof light fits into it.
– The roof light may only be fitted with the hinge-side at the front in the
direction of travel.
6.1 Pressing out the hole
See fig. 2
6.2 Using reinforcing rails
See fig. 3
I
NOTE
You must use reinforcing rails to
 prevent the insulation from being pressed together and the
room wall from being bent
 allow the mounting supports to be fixed on the inside of the
roof
➤ Remove the foam according to the width of your reinforcing rails (not in
scope of delivery) (A).
➤ Fit the reinforcing rails (B).
6
Midi Heki Style 400 x 700
EN