Dometic Midi Heki Style 400 x 700 Instructions De Montage Et De Service page 11

Midi Heki Style 400 x 700
Making a final check
➤ Check visually whether the seal all round the outer frame is against the
roof surface and the mounting supports are aligned.
➤ Tighten the screws about 10 minutes after installation.
See fig. a
A
NOTICE!
Hold the hand crank in the closed position when placing the inner
frame on the outer frame, otherwise the position of the hand crank
(2) will be misaligned with the hexagon part (3).
➤ Press the inner frame into the groove (1) on the mounting supports.
➤ After installing, check the roof light works properly.
➤ Remove the protective film from both sides of the acrylic glass.
I
NOTE
If the protective film is exposed to sunlight for too long, it cannot
be taken off without leaving a residue.
➤ If necessary, enter the new vehicle height and weight in the vehicle doc-
uments.
EN
Installing the Midi Heki Style
9