Dometic CT4050 Instructions De Montage page 27

CT4000
Attaching toilet CT 4xxx
➤ Place the toilet in the desired position.
➤ Tightly fasten the base plate with six bolts (fig. a, page 10).
➤ Bolt the toilet housing to the wall (using a maximum of 7 bolts, not included)
(fig. b, page 10).
➤ CTx4110 only: Place the two covers over the fastening screws in the base plate
(fig. c, page 11).
Installing the control and operating panel of the CT 4xxx toilet
Install the control and operating panel in the wall in the immediate vicinity of the toilet
at an easily accessible location.
I
NOTE
Use the scale template to make the wall cutout (fig. d, page 11).
➤ Prepare an opening in the installation box for the control and operating panel
(fig. e, page 12).
➤ Connect the electrical cables to the connections of the control and operating
panel (chapter "Electrical connection" on page 30).
!
CAUTION!
There is a risk of injury due to the springs springing back!
➤ Press in the retaining springs of the control and operating panel and push it into
the wall cutout (fig. e, page 12).
➤ Follow the instructions in (chapter "Connecting the water supply" on page 28).
➤ Slide in the mobile tank cassette (fig. f, page 12).
EN
Installing the toilet
27