Sony VPL-CX4 Mode D'emploi page 13

qg MS SLIDE key
This key does not function on this unit.
qh Infrared transmitter
To install batteries
1
Push and slide to open the lid, then
install the two size AA (R6) batteries
(supplied) with the correct polarity.
While pressing the lid, slide it.
Be sure to install the battery
#
from the
2
Replace the lid.
Notes on batteries
• Make sure that the battery orientation is
correct when inserting batteries.
• Do not mix an old battery with a new one or
different types of batteries.
• If you do not use the Remote Commander for
a long time, remove the batteries to avoid
damage from battery leakage. If batteries
have leaked, remove them, wipe and dry the
battery compartment, and replace the
batteries with new ones.
Notes on Remote Commander
operation
• Make sure that nothing obstructs the
infrared beam between the Remote
Commander and the remote control
detector on the projector. Direct the
Remote Commander toward the front or
rear remote control detector.
• The operation range is limited. The shorter
the distance between the Remote
Commander and the projector is, the wider
the angle within which the commander can
control the projector becomes.
side.
Location and Function of Controls
13
GB