Attaching The Plasma Display - Pioneer PDK-WM03 Mode D'emploi

3. Attaching the Plasma Display

After attaching the display fittings to the plasma display, attach the plasma display to the wall mounting unit.
1 Catch the upper hooks on the left and right
display fittings into the grooves in the wall
mounting unit.
Upper hook
2 With the upper hooks engaged in the wall
mounting unit grooves, lift the plasma dis-
play directly upward about 1 cm until it stops,
then push the bottom of the plasma display
toward the wall to engage it with the lower
hooks.
Lower hook
3 Tighten the locking screws at the tops of the
left and right display fittings using a screw-
driver.
Reference:
When installing the plasma display in a
high position to which it cannot be lifted
by hand, it can be suspended from the
eye bolts at the tops of the display fit-
tings and lifted with a crane or other
heavy machine. Check that the eye bolts
are tight before doing this.
Reference
:
The plasma display is properly mounted if it does not
move when the lower side is pulled towards you.
Locking screw
E-5
Horizontal Installation