Installing And Removing The Battery Pack - DeWalt DCS571 Guide D'utilisation

English
For the most efficient cutting action, set the depth
adjustment so that one-half tooth of the blade will project
below the material to be cut. This distance is from the tip of
the tooth to the bottom of the gullet in front of it. This keeps
blade friction at a minimum, removes sawdust from the cut,
results in cooler, faster sawing and reduces the chance of
kickback. A method for checking for correct cutting depth
is shown in Figure F. Lay a piece of the material you plan to
cut along the side of the blade, as shown, and observe how
much tooth projects beyond the material.
Fig. F
Bevel Angle Adjustment (Fig. G)
The full range of the bevel adjustment is from 0° to 45°. The
quadrant is graduated in increments of 15°. On the front of
the saw is a bevel angle adjustment mechanism consisting
of a calibrated quadrant and a bevel adjustment knob
Fig. G
11
To Set the Saw for a Bevel Cut
1. Loosen (counterclockwise) the bevel adjustment
knob 11 and tilt shoe to the desired angle by aligning
the pointer with the desired angle mark.
2. Retighten knob firmly (clockwise).
Shoe Adjustment for 90° Cuts (Fig. G, H)
If Additional Adjustment is Needed
1. Adjust the saw to 0° bevel.
2. Retract the lower blade guard. Place the saw on
blade side.
3. Loosen bevel adjustment knob
against the blade and shoe to adjust the 90° setting.
4. Turn the calibration screw
at the proper angle.
10
5
11 .
. Place a square
11
19 so that the shoe will stop
5. Confirm the accuracy of the setting by checking the
squareness of an actual cut on a scrap piece of material.
Fig. H
OPERATION

WARNING: To reduce the risk of serious personal
injury, turn unit off and remove the battery pack
before making any adjustments or removing/
installing attachments or accessories. An
accidental start-up can cause injury.

Installing and Removing the Battery Pack

(Fig. I)
nOTE: For best results, make sure your battery pack is
fully charged.
To install the battery pack 3
battery pack with the rails inside the tool's handle and slide
it into the handle until the battery pack is firmly seated in
the tool and ensure that it does not disengage.
To remove the battery pack from the tool, press the release
button 4 and firmly pull the battery pack out of the tool
handle. Insert it into the charger as described in the charger
section of this manual.
Fig. I
Proper Hand Position (Fig. J)

WARNING: To reduce the risk of serious personal injury,
ALWAYS use proper hand position as shown.
19
into the tool handle, align the
3
4