Intended Use; Liability Disclaimer - Unitec SKF 025 Mode D'emploi

Instructions for use

Intended use

Liability disclaimer

CS Unitec, Inc., 22 Harbor Ave., Norwalk, CT 06850 • Toll-free: 800-700-5919 • Ph: 203-853-9522
Fax: 203-853-9921 • Email: info@csunitec.com • Website: www.csunitec.com
28
The machine is only intended for milling welded edges. The ma-
chine may only be operated in a horizontal position.
Any use other than previously stated is considered as improper
use.
WARNING
Danger from use for other than the intended purpose!
If not used for its intended purpose and/or used in any other
way, the machine may be or become a source of danger.
► Use the machine only for its intended purpose.
► Observe the procedures described in these operating
instructions.
No claims of any kind will be accepted for damage resulting from
use of the appliance for other than its intended purpose.
The risk must be borne solely by the user.
NOTE
► If used commercially, pay attention to compliance with the
accident prevention and occupational safety regulations.
All technical information, data and instructions for commissioning,
operation and maintenance of the machine contained in these
operating instructions represent the latest status at the time of
printing.
The manufacturer assumes no liability for damage or injury result-
ing from failure to observe the operating instructions, use for other
than the intended purpose, unprofessional repairs, unauthorised
modifications or use of non-approved spare parts and accesso-
ries, tools and lubricants.
SKF 25