Milling With The Machine - Unitec SKF 025 Mode D'emploi

Milling with the machine

CS Unitec, Inc., 22 Harbor Ave., Norwalk, CT 06850 • Toll-free: 800-700-5919 • Ph: 203-853-9522
Fax: 203-853-9921 • Email: info@csunitec.com • Website: www.csunitec.com
SKF 25
For milling, proceed as follows:
Align the workpiece to be processed horizontally and secure
‹
it.
CAUTION
Potential damage to property if the machine is improperly
used!
Observe the following instructions to avoid damage:
► Lay the connecting cable so that it cannot be caught by the
running machine.
Mount the guide roller according to the desired application,
‹
see section Mounting the guide roller.
Set the milling angle and chamfer width, see section
‹
the milling angle and Setting the chamfer width.
Insert the plug into the mains socket.
‹
Put the machine onto the workpiece so that the miller does
‹
not move into the workpiece.
Switch on the machine, see section
‹
chine.
NOTE
Observe the following instructions:
► Never attach the reversing plates to the material during
standstill.
► Maintain an even feed.
Slide the machine slowly and evenly from right to left in the
‹
direction of the arrow. The tool operates against the direction
of travel.
Switch off the machine, see section
‹
on/off.
Pull the plug out of the mains socket.
‹
Milling with the machine
Switching on the ma-
Switching the machine
Setting
39