Tool Change - Unitec SKF 025 Mode D'emploi

Tool change

Turning the reversing plates
3
CS Unitec, Inc., 22 Harbor Ave., Norwalk, CT 06850 • Toll-free: 800-700-5919 • Ph: 203-853-9522
Fax: 203-853-9921 • Email: info@csunitec.com • Website: www.csunitec.com
SKF 25
WARNING
Risk of injury!
► Do not use damaged, soiled or worn tools.
► Change tools only when the machine is switched off and at a
standstill. Pull the plug out of the mains socket.
► Only use tools, adapter and accessories that match the
machine.
1
Place the machine onto the upper side (power connecting
‹
cable ).
Remove the screw (2).
‹
Remove the housing (1).
‹
Remove the fixing screw (3), turn the reversing plate and
‹
tighten the fixing screw again.
Repeat the procedure for all reversing plates of the miller.
‹
Replace the housing again and tighten the screw (2).
‹
Tool change
2
41