Maintenance; Customer Service/Service; Troubleshooting; Fault Causes And Remedies - Unitec SKF 025 Mode D'emploi

Maintenance

Customer service/service

Troubleshooting

Fault causes and remedies

Fault
The milling motor does not
run after switching on or
stops during operation.
The automatic circuit
breaker in the electrical
distribution board trips.
NOTE
► If you cannot resolve the problem with the steps described above, please contact
after-sales service.
SKF 25
WARNING
Danger from unqualified repairs!
Unqualified repairs can lead to considerable danger for the user
and cause damage to the machine.
► Repairs to electrical appliances may only be carried out by
the works customer service or by specialists trained by the
manufacturer.
Check the following machine parts regularly for wear:
‹
● Milling head and reversing plates
● Guide rollers
If you have any questions for customer service/service, please
contact BDS.
Possible cause
Plug not inserted into socket.
Automatic circuit breaker
tripped.
Too many appliances con-
nected to the same power
circuit.
The machine is defective.
Maintenance
Remedy
Insert plug.
Switch on the automatic circuit
breaker again.
Reduce the number of appli-
ances on the power circuit.
Contact customer service.
43