Hitachi Koki C 7UR Mode D'emploi page 12

English
2. Adjusting the angle of inclination
WARNING:
If the lever (A) is loose, injury can result. Tighten it securely after adjustment.
You can incline saw blade from 0˚ to a maximum angle of 55˚ in relation to the base.
As shown in Fig. 8 by loosing the lever (A) on the bevel scale, the saw blade may be inclined to an angle of 45˚ in
relation to the base.
If you use inclination angle of over 45˚, as shown in Fig. 9 move the lever (A) to outside, the saw blade may be inclined
to a maximum angle of 55˚ in relation to the base.
Always ensure that the lever (A) is thoroughly tightened after making the desired adjustment.
Lever (A)
Fig. 8
3. Regulating the guide (Rip fence) (Fig. 10, 11)
Install the wing bolt (B) and lock spring on the base. Insert the guide into the base, move it left and right and adjust
the cutting position. Tighten the wing bolt (B) and fi x the guide. The guide can be installed either from the left or the
right side of the main body.
Fig. 10
12
0˚ – 45˚
..................................Optional Accessory
Wing Bolt (B)
Lock
Spring
Base
Fig. 9
Wing Bolt (B), Lock Spring
Fig. 11
45˚ – 55˚
Base
Guide
(Rip Fence)