Sony CDP-CA70ES Mode D'emploi page 5

Hookups
When connecting an audio cord, be sure to match the
color-coded cord to the appropriate jacks on the
components: Red (right) to Red and White (left) to
White. Be sure to make connections firmly to avoid
hum and noise.
CD player
LINE
OUT
L
R
You can adjust the output level to the amplifier
Press LINE OUT LEVEL +/– on the remote. You can
reduce the output level to –20 dB.
When you reduce the output level, "
the display.
Note
If you press the LINE OUT LEVEL +/– buttons on the
remote while recording, the recording level will change
even when it is preset on the tape deck, etc.
• If you have a digital component such as a digital
amplifier, D/A converter, DAT or MD
Connect the component via the DIGITAL OUT (OPTICAL)
connector using the optical cable (not supplied). Take off
the cap and plug in the optical cable.
Note that you cannot use the fade in or out (page 16)
functions when using this connection.
POC-15
Optical cable (not supplied)
CD player
DIGTAL
OUT
OPTICAL
Note
When you connect via the DIGITAL OUT (OPTICAL)
connector, noise may occur when you play CD software other
than music, such as a CD-ROM.
Amplifier
INPUT
CD
L
R
" appears in
FADE
Connecting the AC power cord
Connect the AC power cord to a wall outlet.
Transporting the player
Before transporting the player, follow the procedure
below to return the internal mechanisms back to their
original position.
1
2
Digital component
3
DIGITAL
INPUT
OPTICAL
Getting Started
Getting Started
If you have a Sony component with the CONTROL
A1 jack
Connect the component via the CONTROL A1
You can simplify the operation of audio systems
composed of separate Sony components. For details, refer
to the supplementary "CONTROL-A1
System" instructions.
When using another Sony CD player together with
this player
You can make the supplied remote so that it is effective
only for this player.
• When using a player equipped with the COMMAND
MODE selector:
Set the command mode selector of this player to CD1
(Factory preset position) and that of another player to
CD2 or CD3. Then set the CD 1/2/3 switch on the
remote supplied for each player accordingly.
• When using a player not equipped with the
COMMAND MODE selector:
The command mode of the player without the
COMMAND MODE selector is set to CD 1. Set the
COMMAND MODE selector of this player and the
CD 1/2/3 switch on the remote to CD 2 or CD 3.
Remove all the discs from the disc tray.
Press § OPEN/CLOSE to close the disc tray.
"–NO DISC–" appears in the display.
Wait for 10 seconds, then press 1/u to turn off the
player.
jack.
Control
US
5