Sony CDP-CA70ES Mode D'emploi page 14

Playing CDs
3
Press the number buttons of the tracks you want to
program in the order you want.
To program the track numbered over 10, use the
>10 button.
Last programmed
track
PROGRAM
DISC
After one second
PROGRAM
DISC
To make a correction
Press CLEAR (or p on the player), then repeat this step.
4
To program other discs or tracks, do the following:
To program
All tracks on other discs
Other tracks on the same disc
Other tracks on other discs
5
Press ( (the indicator lights up green) to start
Program Play.
To cancel Program Play
Press CONTINUE.
You can create your program while checking the disc
labels
While the disc tray is open, follow Steps 1 to 5 while
pressing the DISC SKIP button after each step to check
the disc labels. If you close the disc tray before Step 5, the
total playing time appears in the display after a while.
Note that, if the programmed track number isn't found
on the disc, that step is automatically erased.
The program remains even after the Program Play
ends
When you press the ( button, you can play the same
program again.
US
14
Playing order
1 2 3 4 5
A
TRACK STEP
CD1
Programmed tracks
1 2 3 4 5
A
TRACK MIN SEC
CD1
Total playing time
Repeat Step(s)
2
3
2 and 3
The program remains until you erase it or turn off the
player
If you replace discs, the programmed disc and track
numbers remain. So, the player plays only the existing
disc and track numbers. However, the disc and track
numbers that aren't found in the player or on the disc are
deleted from the program, and the rest of the program is
played in the programmed order.
2 5
8
Note
The total playing time doesn't appear when:
—You have programmed a track whose number exceeds 20.
—The total playing time of the program exceeds 200 minutes.
Creating a program using the remote Z
2 5
8
1
Press PROGRAM.
"PROGRAM" appears in the display.
2
Press DISC.
PROGRAM
3
Press the number button of the disc.
PROGRAM
4
Press ENTER to select the disc.
PROGRAM
DISC
When you want to program the whole disc as one
step, skip Steps 5 to 6, and go to Step 7.
5
Press =/+ until the track number you want
appears in the display.
PROGRAM
DISC
1 2 3 4 5 1 2 3 4
6 7
CD1
1 2 3 4 5
1 2 3 4
6 7
CD1
1 2 3 4 5 1 2 3 4
A
6 7
TRACK MIN SEC
CD1
Track number
Total playing time being programmed
1 2 3 4 5
A
TRACK MIN SEC
CD1
5
8 9 10
5
8 9 10
5
8 9 10
2 5
8