Hitachi Koki NT 65A3 Mode D'emploi page 14

English
THE PUSH LEVER AND TRIGGER
MUST MOVE SMOOTHLY.
Push Lever
(2) Adjust the air pressure to 70 psi (4.9 bar 5 kgf/cm
Connect the air hose.
Do not load any nails in the Nailer.
Set the switching device to the upward position (SINGLE ACTUATION MECHANISM).
(Set the switching device to the upward position completely as shown in the diagram.
Otherwise, it will not operate properly.)
THE NAILER MUST NOT LEAK AIR.
(3) Remove the finger from the trigger and press the push lever against the wood.
THE NAILER MUST NOT OPERATE.
Depress Push Lever
14
Trigger
Do not connect
air hose
2
).
Valve Bush
Switching Device
Upward position
Do not pull Trigger