Publicité
Les langues disponibles
Les langues disponibles
ENGLISH
7.6
DELAYED START setup:
Hold down
START
Press
SELECT
to scroll values from 1 to 9 hours.
Press
START
to start the delayed start.
During the waiting time a timer is displayed showing the time remaining before the cycle
start.
WARNING: In case voltage is missing the delayed start is cancelled.
8
Open the water feeding cock. Check the presence of the filter in the tank and make sure it
is clean. Position the item to be cleaned into the TRAY in case of small parts use the
DENTAL BURS TRAY.
Items to be cleaned have to be distributed uniformly and must not touch the tank walls or
bottom.
Fit the tray inside the tank, be sure there is no contact between the tank walls and
the tray.
Cements, alginates, and composites must be treated with specific fluids.
In case of rough dirt on the items, such dirt has to be removed before loading the tools
inside the tray to avoid the drain filter obstruction.
To prevent contact between the steel tray feet and the steel cleaning tank rubber rings are
used. In case rings are missing or damaged replace them with new ones. The wrong use
can cause damages to the tank. Switch on the machine through the switch (L) .
Start the selected cycle pressing
the countdown of the time (estimated time) necessary to complete the cycle. At the end of
the cycle the message ' END CYCLE OK ' is displayed accompanied by an acoustic
alarm. Press OK to go to the cycle selection.
If the door is opened while the device is ON, the current process is immediately
stopped.
When the lid is closed the cycle will restart exactly from the point it has been
interrupted.
At the end of the day close the cock mounted upstream the device.
Do not touch items, the lid or the resistance during drying. Risk of burns.
Drain the reservoir completely before injecting a detergent/disinfectant
different from the one previously held
16
for 8 seconds.
USE INSTRUCTIONS
START
the appliance shows the current cycle phase and
LIVELLO DI
CARICO MASSIMO
Publicité
Chapitres
