INVENTOR PR-ION-20L Manuel D'utilisateur page 19

Table des Matières

Publicité

Les langues disponibles
  • FR

Les langues disponibles

  • FRANÇAIS, page 110
TIMER
Press the "TIMER" button to initiate the auto START or auto STOP function in combination with
the PLUS (+) and MINUS (-) buttons. The "TIMER" indicator and the display will turn on.
• When unit is on, press the Timer button to activate the auto STOP function.
When the unit is off, press this button to activate the auto START function.
• Press the (+) or (-) button to change the time by 0.5 hour increments, up
to 10 hours or by 1 hour increments up to 24 hours. The control panel will
then count down time remaining until START or STOP.
• The time selected will be stored within 5 seconds and the main display will
automatically return to its previous state.
• When the auto START or auto STOP functions is set the Timer indicator is
lit identifying that ON or OFF timers are programmed.
• Turning the unit ON or OFF at any time or changing the timers setting to
0.0 will terminate the Auto Start/Stop function.
• When the control panel window displays code "P2", the Auto Start/Stop
function will be terminated.
ION
Press the "ION" pad to switch on or off the ionizer. Ions will be released in the atmosphere to purify
the air and remove unpleasant and unhealthy particles. By pressing once again this function will
be terminated.
Wi-Fi
Upon installation (initial) of the application Invmate II, please make sure that the dehumidifier
is turned off. Press on the ION button for 3 to 5 seconds continuously, until the indication "AP"
appears on the main display. If pairing between the router and the unit is successful after a period
of 8 minutes, the unit will exit Wi-Fi connection mode and the unit will enter all previously set
functions. If there is a failure in pairing within the 8minute time-frame, the unit will automatically
exit Wi-Fi connection mode.
EN
NOTE: The timer function can either be set to ON or OFF. Setting
ON and OFF simultaneously is not possible.
NOTE: When the unit is remotely accessed, via the Wi-Fi APP, the
LED indicator above the Power button will be active.
19

Publicité

Table des Matières
loading

Table des Matières