Bosch B36CD Série Notice De Montage Et D'utilisation page 33

Ice and water dispenser not working.
Water is dripping from dispenser.
Ice and water dispenser without power.
Ice cube production is low.
Appliance just plugged in.
Recently dispensed a large amount of ice cubes.
Low water pressure.
Door(s) or drawer opened frequently or for an extended period of
time.
No ice production.
Ice and water dispenser is switched off.
Ice cube bin ajar.
No water supply
Water is leaking out of the appliance.
Supply line connection is not tight.
Recently installed filter.
Dispenser drip tray overflowing.
Any other source.
--------
Troubleshooting – what to do? en-us
Air may be trapped in the water system. To remove air, allow water to
dispense for at least 5 minutes and discard. Repeat this step if you still
experience water dripping.
After dispensing, a few drops of water are normal. To minimize, slowly
remove your glass from the dispenser.
Residual ice in the dispenser chute is melting. Make sure the ice chute
is free of ice shavings or pieces.
Disconnect the appliance from power for 1 minute, either by removing
the power cord from the wall outlet or by switching off the circuit
breaker. After reconnecting the appliance, if error persists please con-
tact customer service.
~ "Customer service" on page 34
It can take several hours for the first batch of ice.
~ "Ice maker" on page 18
It could take a few hours until ice cube bin is full again.
Appliance needs to be connected in accordance with instructions.
~ "Water connection" on page 13
Wait at least 2 hours for the temperature in the appliance to cool
down.
Switch on the ice and water dispenser.
~ "Switching the ice and water dispenser and ice maker on or off"
on page 22
Check if the ice cube bin is properly installed.
~ "Ice cube bin" on page 18
Check water connection, make sure the water supply is turned on and
contact a technician if necessary. Switch off the appliance and back
on again. Check whether ice cubes are being produced after 2 hours.
Disconnect the appliance from power for 1 minute, either by removing
the power cord from the wall outlet or by switching off the circuit
breaker. After reconnecting the appliance, if error persists please con-
tact customer service.
~ "Customer service" on page 34
Check if the connections are fastened firmly and the water hose is
undamaged.
Replace the water hose if necessary.
When changing, some water will drip from the filter. Wipe drips dry
with a soft cloth.
~ "Water filter" on page 19
Regularly check the drip tray for drips and clean as necessary.
~ "Cleaning" on page 28
Please contact customer service.
~ "Customer service" on page 34
33