Publicité
Les langues disponibles
Les langues disponibles
1. Press the SavE button (A) to start the function. The
green LED comes on. (Fig. 27)
2. Press the SavE button again to stop the function.
The green LED (B) goes out.
The SavE function stops automatically if the ground
conditions make it necessary to have a higher output.
The SavE function starts automatically when the ground
conditions lets it.
High load function
When the product cuts long or wet grass, the motor
automatically increases rpm. The motor goes back to
standard mode when high load is not necessary.
To stop the product
The product stops automatically if you do not operate it
for 10 minutes. Always turn the safety key to 0 before
you let the product out of view.
1. Release the motor brake handle to stop the motor.
(Fig. 16)
2. Press the ON/OFF button (A) on the control panel
and the green LED (B) goes out. (Fig. 25)
Introduction
WARNING: Before you do maintenance,
you must read and understand the safety
chapter.
For all servicing and repair work on the product, special
training is necessary. We guarantee the availability of
professional repairs and servicing. If your dealer is not a
service agent, speak to them for information about the
nearest service agent.
Do a general inspection
Clean the product
Do a check of the start inhibitor *
Make sure that the safety devices on the product are not defective *
Examine the cutting equipment
Examine the cutting cover *
Do a check of the motor brake handle *
Make sure that the ON/OFF button operates correctly and is not defective
Examine the battery for damage
Do a check of the battery charge
901 - 003 - 25.10.2018
3. Open the battery lid and turn the safety key to 0.
(Fig. 28)
4. To remove the battery, press the two release buttons
and pull out the battery. (Fig. 29)
5. Charge the battery if it is weak. For more
information, see
To get a good result
•
Always use a sharp blade. A blunt blade gives an
irregular result and the cut surface of the grass
becomes yellow. A sharp blade also uses less
energy than a blunt blade.
•
Do not cut more than ⅓ of the length of the grass.
Cut first with the cutting height set high. Examine the
result and lower the cutting height to an applicable
level. If the grass is very long, drive slowly and cut 2
times if necessary.
•
Cut in different directions each time to prevent
stripes in the lawn.
Maintenance
Maintenance schedule
The maintenance intervals are calculated from daily use
of the product. The intervals change if the product is not
used daily.
For maintenance identified with * see instructions in
Safety devices on the product on page 10 .
To charge the battery on page 14 .
Each
Monthly
use
X
X
X
X
X
X
X
X
X
X
Each
season
15
Publicité
