Publicité
Les langues disponibles
Les langues disponibles
Only do the maintenance work
•
written in this operator's
manual. More extensive work
must be done by an approved
service agent.
Put on heavy duty gloves
•
when you use the cutting
equipment. The blade is very
sharp and cuts can easily
occur.
Keep the cutting edges sharp
•
and clean for the best and
safest performance.
Let your service agent
•
regularly examine the product
and make necessary
adjustments and repairs.
Introduction
WARNING: Before you assemble the
product, read the safety chapter.
WARNING: To prevent accidental start
during assembly, turn the safety key to 0,
remove the battery and wait at minimum 5
seconds.
To assemble the handle
CAUTION: Do not twist the cables.
Introduction
WARNING: Before you operate the product,
you must read and understand the safety
chapter.
901 - 003 - 25.10.2018
Replace damaged, worn or
•
broken parts.
Obey the instructions for how
•
to change accessories. Only
use accessories from the
manufacturer.
When not in operation, keep
•
the product, battery and
battery charger apart in a dry,
indoor and locked area. Make
sure that children and persons
that are not approved cannot
get access to the product,
battery or battery charger.
Assembly
1. Align the holes in the upper handle with the holes in
the lower handle.
2. Tighten the knobs on right and left sides fully and
fold the handle up. (Fig. 18)
3. Put the stay in the groove on the cutting cover. (Fig.
19)
4. Attach the 2 stops that lock the stay and the handle.
Push them fully into position. (Fig. 20)
Note: There are 2 stops, one identified with an H
and one with a V. Put the stop with an H on the right
side and the stop with a V on the left side.
Operation
Husqvarna Connect
Husqvarna Connect is a free app for your mobile device.
The Husqvarna Connect app gives extended functions
for your Husqvarna product:
•
Extended product information.
CAUTION: Do not operate the product if
the 2 stops are not attached.
13
Publicité
