Dolmar RM-72.13 H Manuel D'utilisation page 100

EN 10
Fit the battery (5) in place and secure it
with the bracket (6) and the nut (7).
Connect the three red cables (8) to the
positive terminal (+) and the three black
cables (9) to the negative terminal (–)
using the screws supplied. Follow the
instructions given.
Put the column covers (3) and (1) back on
with their screws (4) and (2).
Charge the battery following the battery manufacturer's instructions.
IMPORTANT
ting in, never start the engine until the battery is fully charged!
WARNING!
!
safe handling and disposal.
FITTING THE STEERING WHEEL
Put the machine on a flat surface and
straighten up the front wheels.
Fit the steering wheel (1) onto the protruding
shaft (2) with the spokes directed towards
the seat.
Line up the hole in the steering wheel hub
with the hole in the shaft and insert the pin
supplied (3).
Push the pin in using a hammer, ensuring
that it comes completely through to the opposite side.
NOTE
an awl or a screw-driver of the same size as the pin to push it in the last part.
To prevent the safety device in the electronics card from cut-
Follow the battery manufacturer's instructions regarding
To avoid damaging the steering wheel with the hammer, use
UNPACKING AND ASSEMBLY
7
5
6
9
8
2 3 1