Final Preparation - Ryobi RY48ZTR75 Guide D'assemblage

CHARGE THE MOWER
See Figure 5.
Mower batteries must be charged overnight before first
use. To verify mower batteries are fully charged, check the
battery level indicator.
To charge:
 Insert charger plug into charging port on mower, making
sure it is properly connected.
 Connect charger to power supply using normal household
current of 120 V, AC only, 60 Hz.
 Do not charge in an area of extreme heat or cold.
 Remove the charger from the mower once it is fully charged
and ready for use.
WARNING:
To avoid accidental starting or movement of the mower
that could result in death or serious personal injury,
always remove the start key and set the parking brake
when leaving the mower unattended.
NOTICE:
Always connect the mower to the charger when the unit
is not in use. If it is not possible to leave the mower char-
ger connected, make sure to charge the batteries fully at
least once a month.
CHARGING
PORT

FINAL PREPARATION

CHARGER
PLUG
Fig. 5
TEST THE SAFETY INTERLOCK SYSTEM
See Figure 6.
This mower features a Safety Interlock System to protect
the operator by shutting off the blades if the operator leaves
the seat with the blades running. Test the system to be sure
it is working correctly.
To test:
 Position the mower on a level surface.
 Set the parking brake.
 Make sure drive levers are in the neutral position and the
blade engage knob is down.
 Install start key and turn to ON position.
 Raise blade engage knob to activate blades.
 Briefly lift off the seat, but do not get off the mower.
The blades should shut off within 5 seconds. If they don't,
verify you connected the safety interlock cable as described
on page 6. If the cable is connected but the system still
doesn't function, contact customer service. Do not oper-
ate the mower until the safety interlock system has been
repaired.
8 — English
Fig. 6