Assembly - Ryobi RY48ZTR75 Guide D'assemblage

WARNING:
Strictly adhere to all torque wrench tightening specifica-
tions. Failure to do so could cause serious personal injury.
WARNING:
Do not attempt to modify this product or create
accessories not recommended for use with this product.
Any such alteration or modification is misuse and could
result in a hazardous condition leading to possible serious
personal injury.
WARNING:
To prevent accidental starting that could cause serious
personal injury, always remove the start key from the tool
when you are assembling parts.
CONNECT THE BATTERY
See Figure 1.
When shipped from the factory, the mower's batteries are
disconnected. To connect:
 Press the tabs on the wiring cover. Lift the cover to gain
access to the compartment below.
 Connect the large battery quick-connect plug. This plug
connects the batteries to the mower.
 Reinstall the wiring cover and push down until it latches
securely in place.
TABS
BATTERY
QUICK-CONNECT
PLUG

ASSEMBLY

INSTALL THE SEAT
See Figure 2.
 Remove the shoulder bolts and lock nuts from seat
mounting brackets.
 Place the seat assembly over the mounting brackets and
align holes as shown.
 Reinstall shoulder bolts and lock nuts and tighten securely.
NOTE: Make sure the bolt heads are on the outside and
the lock nuts are on the inside of the mounting bracket
as shown and that the shoulder of the bolt is seated fully
in the mounting bracket. This may be easier to do with
the seat in the raised position.
 Connect the safety interlock cable on the seat with the
plug on the mower as shown.
TABS
WIRING
COVER
Fig. 2
6 — English
SEAT
ASSEMBLY
LOCK
NUT
SHOULDER
PLUG
BOLT
SAFETY
MOUNTING
INTERLOCK
BRACKET
CABLE
SHOULDER
BOLT
LOCK
NUT
MOUNTING
BRACKET
Fig. 2