Use Of The Fryer; Use Of The Control Panel - FriFri Profi+ Manuel D'installation Et Mode D'emploi

5 Use of the fryer

5.1 Control panel

5.2 Use of the control panel

Working thermostat
After connection of the fryer to the supply network, the control panel must be
initialized by pressing the red "Reset" button.
Press the "ON" Button to activate the control panel.
The green LED light indicates that the control panel is ready to use.
The „Standby‟ position is also the fat melting cycle (FMC). This position allows
slow heat up 60°C. The heating element switches on and off during this cycle
in order to melt fat and to heat up fat and oil without smoke and increase the
lifetime of the fat and oil.
The orange LED „Heating phase‟ is flashing during the FMC mode.
The LED becomes stable as soon as the end temperature is
reached.
Start / Stop
Oil pump
Reset / Initializing
Safety thermostat
Control light
heating element
ON / OFF
Button