Husqvarna 545FR Manuel D'utilisation page 13

3. Put the locking pin (C) in the groove on the bolt head
and tighten the bolt fully.
M
A
To attach a trimmer head or plastic blade
1. Put the drive disc (B) on the output shaft.
2. Align the metal cup (P) with the center of the blade
guide on the drive disc.
3. Turn the output shaft to align one of the holes in the
drive disc with the related hole in the gear housing.
4. Put the locking pin (C) in the hole to lock the shaft.
5. Turn the trimmer head/plastic blades (H)
counterclockwise to attach.
H
P
B
C
To adjust the Balance X harness
545FR, 545RX
1. Put the harness on.
2. Push the 2 parts of the breastplate together as
shown in the illustration.
1018 - 005 - 08.06.2020
L
C
3. Tighten the hip strap tightly. Make sure that the hip
strap aligns with the hip.
4. Tighten the chest strap below your left arm tightly.
The chest strap must be tight against your body.
5. Adjust the shoulder strap until the weight is equal on
the 2 shoulders.
6. Adjust the height of the suspension point. For
forestry clearing, the correct height of the
suspension is approximately 10 cm below your hip.
Correct balance of the product on page 16 .
Refer to
7. It can be necessary to lower the suspension point
when you trim grass. If it is necessary, move the
suspension strap (A) to the lower suspension point
on the harness.
8. Tighten the elastic strap (B) to move the load from
the shoulders to the hip.
A
B
13