Publicité
Les langues disponibles
Les langues disponibles
To prevent the switch trigger from being accidentally
pulled, a lock-off button is provided. To start the tool,
depress the lock-off button and pull the switch trigger.
Release the switch trigger to stop.
► 1. Switch trigger 2. Lock-off button
NOTICE:
Do not pull the switch trigger hard
without pressing in the lock-off button. This can
cause switch breakage.
Lighting the lamp
CAUTION:
Do not look in the light or see the
source of light directly.
To turn on the lamp, press the lamp button. To turn off,
press the lamp button again.
1
► 1. Lamp button 2. Lamp
NOTE: The lamp will automatically be turned off if
there is no operation with the tool for one minute.
Electric brake
Electric brake is activated after the tool is switched off.
The brake does not work when the power supply is shut
down, such as the battery is removed accidentally, with
the switch still on.
2
ASSEMBLY
1
CAUTION:
switched off and the battery cartridge is removed
before carrying out any work on the tool.
Installing or removing abrasive cut-
off wheel / diamond wheel
CAUTION:
install or remove the wheel.
CAUTION:
to tighten the bolt securely.
CAUTION:
when the wheel is rotating.
To remove the wheel, press the shaft lock button and
rotate the wheel until the wheel cannot revolve. While
the shaft lock is fully locked, turn the hex bolt counter-
clockwise using the box wrench. Then remove the hex
bolt, outer flange and wheel.
4
2
2
► 1. Shaft lock button 2. Box wrench 3. Tighten
4. Loosen
9 ENGLISH
Always be sure that the tool is
Use only the Makita wrench to
When installing the wheel, be sure
Do not press the shaft lock button
1
3
Publicité
