Armpits - SilverCrest SWWS 240 C1 Mode D'emploi

Armpits

Once the wax disc 9 is completely melted:
1) Open the lid 7 by turning it anticlockwise slightly and lifting it
upwards.
NOTE
► As armpit hairs tend to grow in different directions, they need
to be removed in at least two steps.
2) Raise your elbow upwards and hold it out behind you.
This tightens the skin in the armpit.
3) Pick up a little wax using the flattened edge of the spatula 8.
You can wipe off excess wax on the rim of the appliance.
4) Apply this immediately from the middle of the armpit upwards in
the direction of the elbow. The wax strips should be roughly the
thickness of orange peel. Try to make sure that one end of the
applied wax strip (the end nearer to your elbow) is a little thicker
as you will need to be able to grip this end for removal.
5) After application, you can place the spatula 8 into the tray 6
on the edge of the appliance so that the spatula 8 projects over
the inner bowl 1.
6) Wait about 30–60 seconds until the wax is dry.
7) Grip the wax strip by the thicker end (the end nearer to your
elbow) and pull it off downwards with a rapid movement against
the direction of hair growth.
8) To depilate the lower part of the armpit, apply the wax from the
middle of the armpit towards the bottom.
9) Wait about 30–60 seconds until the wax is dry.
SWWS 240 C1
GB │ IE │
13 ■