Christopeit Sport EMS 6 Notice De Montage Et D'utilisation page 25

Pulse Rate:
The whole set of heart rate detector include 2 sensors each side. Each sensor
has 2 pieces of metal parts. The correct way to get detected is to gently
hold both metal parts each hand. With the good signals picked up by the
computer, the heart mark in the HEART RATE Display shall flash. Sometimes
the heart rate value is not useable, based on wet hands or any other contact
problems during exercising. If you need high accuracy heart rate value you
have to use an external heart rate measurement with a pulse belt.
"WARNING" Heart rate monitoring system may be inaccurate. Over exercise
may result in injury or death. If you feel faint stop exercising immediately.
Cleaning, Checks and Storage of the Ergometer
bike:
1. Cleaning
Use only a less wet cloth for cleaning. Caution: Never use benzene,
thinner or other aggressive cleaning agents for surface cleaning as
this damage caused.
The device is only for private home use and for use suitable indoors.
Keep the unit clean and moisture from the device.
2. Storage
Plug out the power supply unit while intending the unit for more than
4 weeks not to use. Push the saddle slide toward the handlebar and
the seat support tube as deeply as possible into the frame. Choose
a dry storage in-house and put some spray oil to the pedal bearings
left and right, to the thread of the handlebar bolt, and on the thread
of the quick release for saddle support.
Cover the bike to protect it from being discolor by any sunlight and
dirty through dust.
3. Checks
We recommend every 50 hours to review the screw connections for
tightness, which were prepared in the assembly. Every 100 operating
hours, you should put some spray oil at the pedal bearings left and
right, to the thread of the handlebar bolt and to the thread of quick
release for saddle support.
Troubleshooting
If you cannot solve the problem with the following information,
please contact the authorized service center.
Problem Possible Cause
Computer has No power
no value at Dis- adapter is well
play if you press plugged or wall
any key. power is without
power.
Computer is Sensor impulse
not counting missing base on
data and do not not well plugged
switch on after connection
start cycling.
Computer is Sensor impulse
not counting missing base on
data and do not not correct posi-
switch on after tion of sensor.
start cycling.
No pulse value Pulse cable is
not plugged in.
No pulse value Pulse sensors
not well connec-
ted
25
Solution
Check that the power adapter
is properly plugged in, possibly
with another electric device
check if the wall power is fine.
Check the plug connections at
computer and inside of handle-
bar support.
Take off the cover and check
the distance between magnet
and Sensor. The magnet at
turning belt wheel should have
only less than < 5mm distance
against the sensor position.
Check the separately pulse
cable is well connected with
computer.
Screw out the screw for pulse
measurement and check if
plugs are well connected and no
damage at pulse cable.