Replacing The Taillight; Removing The Front Wheel - Gazelle Innergy Manuel De L'utilisateur

41

Replacing the taillight

• I f the taillight is damaged, you must replace it to prevent
moisture from entering into the battery. (Photo 41)
• L oosen the screw of the taillight using a Phillips
screwdriver. (Photo 42)
• H old the taillight with one hand and use your other
hand to hold the battery. Now pull the taillight loose
42
from the battery. (Photos 43 + 44)
• P ress on the new taillight. Make sure that it fits tightly in
all corners and other places and that the rubber upper
flap goes over the taillight. (Photo 45)
• Tightly screw the taillight back onto the battery.
(Photo 46)
43
44
45
46
76
216-03-1708 Gewijzigde herdruk Handleiding Innergy.indd 76-77

Removing the front wheel

• T he below instructions are an addition to the
actions described in the general Gazelle user
manual. You must first follow the below instructions
before you can remove the front wheel.
• R emove the battery from the bike (see previous
instructions).
• L oosen the two screws of the connector cap on
the front fork using a size 4 Allen key. (Photo 47)
• Remove the front part of the cap. (Photo 48)
• C arefully take the plug connection out of the cap
with dry hands and pull the two plug halves apart.
(Photo 49)
• A void all contact with the contact pins of the
plugs.
• H old the bottom part of the cable and carefully
take it out of the 2 cable guide brackets. Make sure
that you do not damage the cable and plug. The
upper bracket is located in the area of the
mudguard attachment (see 1 on Photo 50), the
lower bracket is situated beneath the front axle's
cap nut (see 2 on Photo 50).
• N ow loosen the cap nuts and follow the
instructions for replacing a wheel in the general
user manual.
47
48
49
50
1
2
77
05-08-2008 12:00:53