Error Messages On Your Display - Gazelle Innergy Manuel De L'utilisateur

4 Eco/boost button for changing pedal assistance
This button covers 2 modes.
Eco =
Boost = the mode for short, powerful assistance.
If you have pressed the on/off button and have switched
on the system, the system automatically starts in the
"eco" mode. Press the eco/boost button 1 time if you
want to bike with boost assistance. To switch back to
30 eco, press the eco/boost button once more. This button
has no function if you haven't switched on the pedal
assistance first via the on/off button (1).
i

72
216-03-1708 Gewijzigde herdruk Handleiding Innergy.indd 72-73
(Photo 30)
the mode for long lasting assistance.
Your dealer can set both modes precisely
according to your wishes. Thus you can find your
optimum balance between the level of pedal
assistance in relation to road and riding
characteristics on one side and radius of action
on the other.
Make sure to never press more than 1 button
at a time. If you inadvertently have done so,
press the eco/boost button for 3 seconds in
order to return to your normal display settings.

Error messages on your display

• Y our display can show error messages. Below it
is explained what the messages mean and what
action you need to take.
• O n the lower right of your display the indication
"Err" will show, followed by a number. "Err" stands
for error message. The decimal in the speedometer
forms the second part of the error message.
• If the display shows a wrench, it means
that you have to take the bike to the dealer and
that you can't ride with pedal assistance.
Err 1.1 This battery is not registered for this
bike
You can't ride with this battery because the bike doesn't
recognise the battery's serial number. Go back to the
dealer with your bike, the receipt and the battery. Your
dealer will register this and other batteries for you.
This also applies to, for instance, the battery from your
spouse's bike or a spare battery. As long as the dealer
hasn't registered this battery, the pedal assistance will
not function. (Photo 31)
Tip: If more people in your household own a Gazelle
Innergy, have the dealer register all batteries in all
bikes. Then it doesn't matter what battery you put
in what bike.
Err 1.2 Battery temperature (was) too high when
charging
The battery temperature has exceeded 55°C (131°F).
Make sure that the bike is not exposed to direct sunlight
or is parked against a heater. If you charge the battery
separate from the bike, make sure that it doesn't sit on
or next to the heater or in direct sunlight. As soon as
the battery has cooled off, it will resume charging. This
message will disappear from the display automatically.
If you frequently get this message, we request you to
contact your dealer. (Photo 32)
31
32
73
05-08-2008 12:00:44