The Battery; Checking The Battery Status; Placement And Removal Of The Battery - Gazelle Innergy Manuel De L'utilisateur

Checking the battery status

By pressing the button on the taillight, you can easily see how
much battery capacity is left. (Photos 1 + 2)
The taillight consists of 5 LED light bulbs:
1 on the left, 3 in the back and 1 on the right.
1
• I f all 5 light bulbs are on, it means that there is 100%
capacity
• If 4 light bulbs are on, it means that there is 80% capacity
• If 3 light bulbs are on, it means that there is 60% capacity
• If 2 light bulbs are on, it means that there is 40% capacity
• If 1 light bulb is on, it means that there is 20% capacity
A
• I f no light bulbs are on, you battery has between 0 and 20%
capacity.
2
i
• I f the battery has been slid into the bike correctly, you can
also read the battery capacity off of the display (see chapter
display, explanation display #6).
3
• T he number of blocks that is shown on the display for the
battery capacity equals the number of taillight bulbs that
are on. (Thus, if 4 battery blocks are visible on the display
this is equivalent to 4 burning LED light bulbs when the
button on the taillight is pressed). (Photo 3)
4
62
216-03-1708 Gewijzigde herdruk Handleiding Innergy.indd 62-63
If your battery is out of power, there is still sufficient
residual capacity left for your lights to stay on for a
considerable amount of time.

Placement and removal of the battery

Placement
• Make sure that the bike sits firmly on the kickstand.
• H old the battery with two hands, direct the front of the
battery in a way so that the recesses on the sides of the
battery line up with the battery guides on the luggage
carrier. (Photo 4)
• E nsure that the bike key is in the battery lock and push the
battery in a forward direction until it can't go any further.
Beware: the bike key MUST be in the battery lock or else
you can't completely push in the battery. (Photo 5)
• T ake the key out of the battery lock, put it back into the bike
lock and unlock the bike. (Photos 6 + 7)
• C heck if the battery is properly fixed by lightly pulling on
the battery. (Photo 8)
• I f this is not the case, you must repeat the 3 previous steps.
If the battery has been slid in correctly, the display will be
activated as well.
5
6
7
8
63
05-08-2008 12:00:31