Spare Parts; What If There Are Problems - Beurer LB44 Mode D'emploi

8. Spare parts

Tip!
If the water is hard, we recommend using the
optional anti-limescale filter.
Anti-limescale filter (optional)
Order number 162.843. Please contact the
national service address.

9. What if there are problems?

Problem
No LED display
Red LED
No mist is produced
The mist has a strange
smell
Strange noise
Cause
The mains cable is not
plugged in.
The control dial is at its
minimum position.
The water level is too low; the
water tank is empty.
The LED lights up green.
The LED lights up red.
The LED display does not
light up.
The device is new.
Stale or dirty water.
The water tank is not
positioned correctly on the
base unit.
16
Important!
• If the anti-limescale filter does not prevent
limescale build-up, or if white deposits
form on or in the device, the anti-limescale
filter should be replaced.
• The service life of the anti-limescale filter
is around two to three months at most.
• If the device is not used for a relatively
long time, the anti-limescale filter must be
removed from the water tank and dried
out.
Fitting the anti-limescale filter
> Lift the water tank and rotate it
> Open the screwed plug on the water tank
> Screw the anti-limescale filter onto the
screwed plug on the inside
> Tightly close the water tank using the
screwed plug
Solution
> Insert the plug and switch on the
device
> Turn the control dial clockwise
towards the maximum position
> Fill the water tank
> Turn the control dial clockwise
towards the maximum position
> Fill the water tank
> Insert the plug and switch on the
device
> Remove the water tank, turn the
screwed plug and remove it
> Air the open, emply water tank in
a cool, dry place for twelve hours
> Empty the base unit and the water
tank and clean them thoroughly
> Fill the water tank with fresh water
> Lift up the water tank and position it
correctly on the base unit
The tank should sit tightly on the base
unit.