Hitachi C 10FS Mode D'emploi page 22

English
Head
r
Miter Angle
Scale
11. Groove cutting procedures
Grooves in the workpiece can be cut as indicated in Fig. 38 by adjusting the 8mm depth adjustment bolt.
Cutting depth adjustment procedure:
(1) Loosen the 8mm wing nut and turn the 8mm depth adjustment bolt by hand.
(2) Adjust to the desired cutting depth by setting the distance between the saw blade and the surface of
the base (see b in Fig. 38).
(3) The 8mm wing nut must be properly tightened after the adjustment has been completed.
NOTE:
When cutting a single groove at either end of the workpiece, remove the unneeded portion
with a chisel.
22
Bevel Angle Scale
q
Fence
Base
Turntable
Fig. 34
Fence
A
B
Table on Base
Fig. 35
Cut grooves with saw blade
a
b
Fig. 38
Head
e
Fence
Miter Angle
Turntable
Scale
Fig. 36
Fence
A
Table on Base
Fig. 37
8mm Depth Adjustment Bolt
8mm
Wing Nut
b
Bottom Line of
the Groove
Fig. 39
Bevel Angle Scale
w
Base
B
Turntable