Oblique Angle - Hitachi C 10FS Mode D'emploi

English
3. Checking the saw blade lower limit position
8mm Wing Nut
Table Insert
Fig. 10

4. Oblique angle

6mm Bolt (C)
(Stopper for right 45°
bevel angle)
Fig. 11
5. Securing the workpiece
WARNING:
6. Installing the holders ... (Optional accessory)
6mm
Knob Bolt
(Optional
Accessory)
Holder
Steel
Square
Fig. 12
14
Check that the saw blade can be lowered 13/32" to 27/64" (10mm to
8mm Depth
Adjustment
11mm) below the table insert.
Bolt
If necessary, adjust as follows:
(1) Loosen the 8mm wing nut and the two 8mm nuts on the 8mm
8mm Nut
(2 pieces)
(2) Turn the 8mm depth adjustment bolt as necessary to set the
(3) Once the adjustment is complete, fully tighten the two 8mm
Turntable
NOTE:
Before the power tool is shipped from the factory, it is adjusted for
6mm Bolt (A)
(Stopper for 0°)
0°, right angle, left 45° bevel cutting angle and right 45° bevel cutting
angle with the 6mm bolt (A), 6mm bolt (C) and the 8mm bolt (B).
When changing the adjustment, change the height of the 6mm bolt
(A), 6mm bolt (C) or the 8mm bolt (B) by turning them.
When changing the bevel angle to the right 45°, pull the fixing pin
on the direction shown in Fig. 11 and incline the motor head to the
right.
Fixing Pin
When adjusting the motor head to 0°, always return the fixing pin
Indicator
to its initial position.
Always clamp or vise to secure the workpiece to the fence; otherwise the workpiece
might be thrust from the table and cause bodily harm.
The holders help keep longer workpieces stable and in place dur-
ing the cutting operation.
(1) As indicated in Fig. 12, use a steel square for aligning the upper
(2) After aligning, secure the holders with the 6mm knob bolts (Op-
Base Surface
depth adjustment bolt.
lower limit position.
nuts and the 8mm wing nut.
Before tightening the two 8mm nuts and the 8mm wing
nut, confirm that the saw blade is adjusted so that it will
not cut into the turntable.
edge of the holders with the base surface.
tional accessory).