afriso OM 1 Notice Technique page 85

8.2.2 Replacing the mains fuse F1
ELECTRIC SHOCK CAUSED BY LIVE PARTS
• Disconnect the mains voltage supply before performing the work and ensure
that it cannot be switched on.
Failure to follow these instructions will result in death or serious injury.
Verify that the mains voltage is interrupted and cannot be switched on.
1. Open the control unit, see Page 21.
2. Remove the transparent cover from the mains fuse F1.
3. Insert a new mains fuse F1, see Page 16.
4. Refit the transparent cover.
5. Connect the flat cable to the connector.
6. Close the control unit, see 1 above.
7. Apply mains voltage.
Maintenance
DANGER
EN
34